Learn how to replace the shock absorbers in a GE washer. This video covers how to disconnect hoses, wiring, and the lid switch, and remove the top and side screws to access the shocks. It shows how to release and remove the shock rods and bushings.

Learn how to test and remove the lid switch in a GE washer. This video explains the safety function of the lid switch, how to test it with a multimeter, and why it should never be bypassed. It also covers the importance of maintaining slack in the wiring to avoid damage during off-balance loads or part replacement.

Learn how to test the washer motor in a GE washing machine. This video covers how to use a multimeter to check spin and agitation speeds via specific wire pairs, inspect the motor pulley for damage, and understand how the motor controls agitation and spin.

Learn how to troubleshoot and clean the washer pump. This video explains how a continuous fill may be caused by a cracked float box or a damaged float switch tube. It also covers testing the float switch with a multimeter—no ohm reading means the diaphragm is faulty and needs replacement. Includes a tip for adjusting the float switch set screw to prevent overfilling during large loads.

Covers new A2L refrigerants (R-454B, R-32) requiring special black gauges and hoses compatible with A2L. Explains that standard hoses can fail, charging tanks have left-handed threads needing adapters, and emphasizes zeroing gauges before refrigerant changes.

Covers the key differences between R-22, blended refrigerants (like MO99/438A), and 410A, including safe handling procedures, charging techniques, and labeling recommendations.

Explains how to test a fan motor by checking shaft movement and measuring resistance between terminals. Also covers diagnosing bad windings and freeing stuck bearings with oil if ports are available.

Learn how to test single and dual capacitors that power motors (HVAC, refrigerators, pumps), interpret microfarad (UF) readings, and identify failures like bulging. Understand that hard start kits are temporary aids and how to match UF and voltage specs when replacing.

Explains how to charge mismatched HVAC systems when superheat and subcooling aren't reliable. Covers pressure targets for R-22 and 410A, signs of proper charge, and the importance of rechecking after peak demand.

Learn how to test a scroll compressor by identifying its run, common, and start terminals and checking resistance with a multimeter.